Advertisement
Hook the connecting bracket onto the screws temporarily
tightened in step .
Fasten the right side of the connecting bracket using a
long screw and the provided screwdriver. Also tighten the
two screws temporarily tightened in step .
Note
❒ If you have the 1000-sheet paper feed unit or 2000-sheet Large
Capacity Tray installed, proceed to step .
If you have the 500-sheet paper feed unit installed,
change the position of the connecting bracket on the side
of the 2 tray finisher to the lower level. Remove the two
screws using the provided screwdriver, the move the
connecting bracket down, and then refasten the screws.
Place the printer's trail on the 2 tray finisher, and then
slide until it stops.
Fasten the rails using a long screw provided screwdriver.
Slowly push the 2 tray finisher toward the printer until it
stops.
Remove the tape fastening the cable to the 2 tray
finisher.
ZHXH350J
Advertisement
