Using Headphones; Connecting To Ac Power; Mounting The Amplifier; Turning The Amplifier On - PYLE Audio PT-610 User Manual

Using headphones

To listen privately, or to monitor sound sources, connect a pair of low
impedance stereo headphones (not supplied) with a 6.35 mm plug into
the PHONES jack on the amplifier front panel.
Please listen safely. Follow these recommendations:
Do not listen at extremely high volume levels. Extended, high-volume
listening can lead to permanent hearing loss.
Always start with the volume control set to LOW level BEFORE you put
the headphones on. Then gradually increase the volume as necessary.
Once you set the volume, do not increase it. Over a period of time, your
ears adapt to the volume level, so a volume level which does not cause
immediate discomfort may still be actually damaging your hearing.
Connecting to standard AC power
After making all other connections, set the POWER switch to OFF
position. Then connect the power cord to a standard AC outlet.

Mounting the amplifier

The PT610 is designed to accept standard rack mounting installations.
Two slots on each end of the front panel make it suitable for such an
installation.
Tightly secure four mounting screws (not supplied) through these four
slots and into your standard electronics equipment rack.

Turning the amplifier on

1.Turn on the audio input source equipment which is connected to the
amplifier INPUT jacks.
2.Set all volume levels (Master, Mic 1-3, Mic 4/AUX and Line) to their
minimum level settings.
3.Push in the power switch to turn the amplifier on.
4.Adjust the controls of MIC 1-3, Mic4/AUX and LINE to the desired
volume and balance.
11