Hawk HA-101 User Manual

Intelligent alarm immobiliser

Advertisement

Quick Links

ALARM • IMMOBILISER
HA-101
User's Manual
Guide to intelligent Alarm Immobiliser
Manufacturer:
COMMERCIAL ELECTRONICS
264 HAYDONS ROAD
WIMBLEDON
LONDON SW19 8TT
UK
Tel: +44 020 8404 7105 Fax: +44 020 8404 7104
http://www.hawkcaralarm.com e-mail: info@hawkcaralarm.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HA-101 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Hawk HA-101

  • Page 1 ALARM • IMMOBILISER HA-101 User’s Manual Guide to intelligent Alarm Immobiliser Manufacturer: COMMERCIAL ELECTRONICS 264 HAYDONS ROAD WIMBLEDON LONDON SW19 8TT Tel: +44 020 8404 7105 Fax: +44 020 8404 7104 http://www.hawkcaralarm.com e-mail: info@hawkcaralarm.com...
  • Page 2 May we take this opportunity to thank you in purchasing the Hawk HA-101 car alarm & immobiliser. Please follow the user’s manual for better understanding and operation of the system. The system complies with: THATCHAM CATEGORY 1 (ISSUE 2) standards.
  • Page 3: Setting And Unsetting

    HA-101 – User’s Instructions GENERAL INTRODUCTION HA-101 is a reliable car alarm system, which provides 2 designs to prevent the car thieving. The first design is to use the loud siren. When any illegal intrusion happens, the siren will sound loudly to warn the intruder. The second design is to use an immobilisation system to disable the engine start.
  • Page 4 3. ALARM PRIOD AND SOUNDING CYCLE a. Whilst arming, if any detector is triggered, the siren will sound. For any single trigger (e.g. open the door and close the door back), the siren will sound one cycle only. (One cycle is: sound 27 seconds and stop 12 seconds.) b.
  • Page 5 8. WINDOW CLOSE (optional accessory HA-64 required) (optional accessory RELAY required) 9. TRUNK RELEASE When system in arming mode, press button 2 for 3 sec, system will disarm and then release trunk, when system in disarming mode, press button 2 for 3 sec, system will release trunk directly.
  • Page 6 j. And then LED will be ON again. It means you can code another touch key now. The system allows you to code 4 touch keys in total. (When the fifth touch key is coded, the code for the first touch key will be cleaned) k.
  • Page 7 d. While changing the battery of the remote, make sure to use the correct type and position it in the correct direction. It is recommended to change the battery at least every 6 months. For HA-12T: use 27A alkaline battery. e.
  • Page 8 N O T E S Manufactured by Commercial Electronics • Great Britain • © Commercial Electronics 2005...

Table of Contents