NORMAL OPERATION Arm Alarm Disarm alarm Bike Finder Remote start ARMING THE ALARM SYSTEM NORMAL ARMING MODE To arm the alarm system, turn the ignition switch OFF, press the button, indicators will flash once; with single audible bleep LED starts to flash the alarm system will enter into the arming status.
EMERGENCY KEY RESET: If the remote control is lost the owner can disarm the alarm with the key. Please refer to steps below: Keep the ignition switch off position for 1 second. Turn the ignition switch ON/OFF 5 times and it will disable alarm immediately. Make sure that each ON/OFF sequence is completed in 1 second otherwise the system will ignore it.
Page 4
CEASE THE USE OF THE UNIT AND SEEK THE ASSISTANCE OF AN AUTHORIZED DEALER TO REPAIR OR DISCONNECT THE INSTALLED REMOTE START MODULE. HAWK CAR ALARM WILL NOT BE HELD RESPONSIBLE OR PAY FOR INSTALLATION OR REINSTALLATION COSTS. REMOTE ENGINE START PROCEDURE...
MEMORY FUNCTION During the alert state, if the alarm is detached from the cable harness, when restored it will “remember” the state in which was, preventing in this way every attempt of tampering. LEARNING TRANSMITTER CODES: (We have already done this for you!!!) This alarm system can support up to 3 remote controls.
Page 6
GENERAL SECURITY The HAWK HA-X40 alarm/immobiliser system will provide an effective deterrent against theft. It will not in itself guarantee that your motorcycle is not stolen or damaged. We strongly advise that your alarm is used conjunction with basic anti-theft precautions.
Page 7
HAWK dealer; and the unit is returned to HAWK, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer’s name, telephone number and address;...