Related Manuals for Lincoln Electric LTP SERIES
Summary of Contents for Lincoln Electric LTP SERIES
- Page 1 IM2074 06/2016 REV00 LTP SERIES HAND HELD TIG (GTAW) TORCHES CE OPERATOR’S MANUAL ENGLISH GRAPHICS MAY VARY LINCOLN ELECTRIC EUROPE S.L c/o Balmes, 89 - 8 , 08008 Barcelona, Spain www.lincolnelectric.eu...
- Page 2 Easy Start English English...
- Page 3 Download You can download this manual: from http://www.lincolnelectric.com/en-gb/support/Pages/operator-manuals-eu.aspx English English...
- Page 4 Electromagnetic Compatibility (2004/108/EC) and has been designed in compliance with the following standards: EN 60974-7 May 2016 Pietro Terranova Accessories Product Manager EMEA Lincoln Electric Europe S.L, c/o Balmes, 89 – 8° 2 , 08008 Barcelona, Spain 12/05 English English...
-
Page 5: Table Of Contents
12/05 THANKS! For having choosen the QUALITY of the Lincoln Electric products. Please Examine Package and Equipment for Damage. Claims for material • damaged in shipment must be notified immediately to the dealer. For future reference record in the table below your equipment identification •... -
Page 6: Safety
Failure to follow the instructions in this manual could cause serious personal injury, loss of life, or damage to this equipment. Read and understand the following explanations of the warning symbols. Lincoln Electric is not responsible for damages caused by improper installation, improper care or abnormal operation. -
Page 7: Preparation And Operator Instructions
ARTIFICIAL OPTICAL RADIATION: According with the requirements in 2006/25/EC Directive and EN 12198 Standard, the equipment is a category 2. It makes mandatory the adoption of Personal Protective Equipments (PPE) having filter with a protection degree up to a maximum of 15, as required by EN169 Standard. FUMES AND GASES CAN BE DANGEROUS: Welding may produce fumes and gases hazardous to health. - Page 8 The manufacturer reserves the right, whenever necessary and without prior notice, to amend these instructions as a result of clerical or printing errors, incorrect information, or the addition of improvements. Except for the tungsten electrode – which must be ordered separately – our welding torches are delivered ready for immediate connection to our welding machines.
-
Page 9: Specifications
Specifications Operating Temperature -10° C ~ 55° C (14° F ~ 131° F) Storage Temperature -25° C ~ 55° C (-4° F ~ 158° F) Relative air humidity Up to 90% at a temperature of 20° C “Ergo” / “Flex Ergo” types “V”... -
Page 10: Installation
Installation WARNING Also follow operating instructions provided with the welding machine. WARNING! The power source must be deactivated! Gas-cooled connection Read the instructions of your welding machine prior to use so as to be sure how to attach your welding torch. - Page 11 Colour coding switching cable The LTP torches can be fitted to a large variety of welding machines according to the diagram below and according to the switching module functionality of the torch. SWITCH MODULE FUNCTION WIRE/COLOR MARKING 1 button switch start/stop orange + brown start/stop...
-
Page 12: Maintenance
Assembly front side of welding torch A) Place collet (1) in collet body (2) and screw these by hand on torch body (3) B) Screw ceramic cup (4) on collet body (2) C) Insert Tungsten electrode (5) from the rear; make sure electrode has sufficient length. -
Page 13: Weee
Use the illustration of assembly page and the end of the catalogue to determine where the part is located • for your particular code. Do not use this part list for an item if its code number is not listed. Contact the Lincoln Electric Service • Department for any code number not listed.