Safety Regulations For Finecoat Spraying - WAGNER FineCoat 7000 S Operating Manual

Safety regulations for FineCoat spraying

All local safety regulations in force must be observed.
The following is to be observed:
1. Read the operating instructions carefully and follow the
instructions laid down in them in order to avoid risks.
2. Only coating materials with a flash point of 21 °Cor
over may be sprayed, without additional heating.
3. The equipment may not be used in factory shops and
offices in which the explosion protection regulations
apply.
4. There must not be any ignition sources in the area
when spraying; e.g. , open fires and smoking; also
cigars and pipes are sources of ignition, as well as
sparks, red hot wires, hot surfaces, etc.
5. Warning: Danger of injury by injection! Never point
spray gun at yourself, other persons or animals.
Danger
6. Wear breathing equipment when spraying.
The user should be supplied with a breathing mask.
In order to avoid occupational diseases, the working
instructions provided by the manufacturer of the
materials, solvents and cleaning agents used must be
complied with during preparation, working with and
cleaning the equipment. Protective clothing, gloves and,
if necessary, protective skin cream is required to protect
the skin.
7. Warning: When working with the FineCoat paint
spraying system, both indoors and outdoors, care
should be taken that no solvent vapours are driven
to the motor-operated blower or that no solvent
containing vapours form in the area around the paint
spraying system. Place the motor-operated blower on
the opposite side to the object to be sprayed.
When working outdoors take wind direction into
account.
When working in closed places a sufficient ventilation
must be ensured to remove the solvent vapours.
The distance from the motor – operated blower to the
object to be sprayed must be at least 3 m.
12
GB
8. Warning: The device FineCoat 7000 S is not splash
proof. It should not be used, neither outdoors in the
rain nor be sprayed with water nor washed down nor
immersed in liquid.
Do not use the device in damp or wet environments.
9. Extraction systems should be installed on-site according
to the local regulations.
10. The object to be coated must be earthed.
11. The spray gun should be secured against unintentional
operation during breaks in work (see page 16, fig. 11).
12. When cleaning the device with solvents, it should never
be sprayed back into a container with only a small
opening (bunghole). An explosive gas/air mixture can
form. The container must be earthed.
13. Always remove plug from socket when carrying out
work on electrical components.
14. Work or repairs on the electrical equipment should only
be carried out by a professional electrician, even if there
are instructions regarding such work in the operating
instructions. No liability will be accepted for improper
installation.
FineCoat 7000 S