Safety Requirements - WAGNER PC 15 Service Manual

Safety requirements

All local safety regulations in force must be
observed.
In addition, you must comply with the following:
1. Use of the mortar spraying machine
The mortar spraying machine Plast Coat 15 is
designed only for the spraying the materials
described in the operating manual.
Any other use is not permitted. The
manufacturer cannot be held liable for any
damage resulting from this. In such cases, the
risk will be borne solely by the user.
Intended use also includes compliance with the
Operating manual and compliance with the
inspection and servicing conditions.
Always keep the Operating manual ready at
hand at the machine location.
2. The mortar spraying machine Plast Coat 15
may only be operated with a pressure gauge.
Only the mortar hose prescribed by the
manufacturer may be used.
3. Only use identified mortar hoses with an
operating pressure of at least 40 bar.
4. Personnel safety
Always wear protective goggles, protective
clothing and gloves and, if necessary, skin barrier
cream and breathing equipment, to protect your
eyes, skin and respiratory system.
Never uncouple mortar hose while it is still under
pressure.
Note pressure gauge!
Wear protective goggles!
Never aim spray lance at any person!
5. Breathing masks
Breathing masks must be provided for the
operator to protect against mineral dust.
6. Only connect to the mains supply using a
special distributing point, e.g., using a fault
current protective system with INF ≤30 mA.
7. Do not put a load of more than 450 watts on the
socket on the control unit.
8. The master switch has an EMERGENCY OFF
function.
9. Prevent the socket for the remote control on the
control unit from getting dirty.
Always leave the coupler plug of the remote
control line on the mortar hose screwed complete
into the control unit.
10. Danger of injury from the screw
conveyor.
Never put your hands into the
receptacle when the mortar
spraying machine is running.
DANGER
Never turn on the mortar spraying machine
when the grating has been removed from the
receptacle or when the receptacle has been
removed.
11. Cleaning and servicing
Never uncouple mortar hoses under pressure.
Before uncoupling, check pressure on the
pressure gauge.
Turn off the mortar spraying machine for cleaning
and maintenance work. Pull out mains plug and
ensure that it cannot be plugged back in
unintentionally.
Do not spray the motor or control unit of the
mortar spraying machine with water jet, high-
pressure or steam cleaning equipment. Water
could penetrate the machine and cause a short-
circuit.
12. Electrical equipment
Work on the machine's electrical equipment may
be carried out only by a qualified electrician.
The electrical equipment must be inspected regu-
larly. Defects such as loose connections or
scorched cables must be remedied immediately.
13. Keep the labels on the mortar spraying
machine clean and legible.
14. Positioning on uneven ground
The front of the mortar spraying machine must
point upwards to avoid that the machine slips
away.
2