Changing The Nozzle - WAGNER FineCoat 7000 S Operating Manual

12. Apply a fine coat of silicone-free oil to the marked areas.

13. If the paint spray gun is not used for any length of time, it
should be cleaned and protected by applying a fine coat
of silicone-free oil.

Changing the nozzle

Note: Make sure that the air cap, the tip and the needle have
identical markings.
1. Remove the adjusting ring, the air cap and the spring plate
(fig. 13).

2. Fig. 14 – Loosen the needle seal with the open-end
wrench (1). Remove the material adjusting knob (2) and
the pressure spring (3). Open trigger of the spray gun to
facilitate needle removal (4).
FineCoat 7000 S
GB

3
2
3. Remove the needle (5) (fig. 15).

5
4. Remove the tip with the enclosed special socket wrench
(fig. 16).

Reassemble with the new nozzle set in reverse order.
Attention: The needle seal screw connection must be read-
justed after reassembly.
1
4
17