Page 1
MULTIFUNCTION OVENS - 60cm MODEL OV6-10 MODEL OV6-11...
Page 3
Dear Customer, we would like to thank you and congratulate you on your choice. This new product has been carefully designed and built using top quality materials, and meticulously tested to ensure that it meets all your culinary requirements. Please read and observe these simple instructions, which will enable you to achieve excellent results from the very time you...
Contents User instructions, 5 First use, 5 Self-cleaning panel, 5 Respect for the environment, 5 Control panel, 6 Instructions for use: - conventional cooking, 6 - fan cooking, 6 - grill cooking, 7 Thermostat, 7 Electronic timer, 7 IMPORTANT Setting the clock, 8 data plate is accessible even Setting the clock, 8 with the oven fully installed.
User instructions rst time you use the oven Self-cleaning catalytic panels Clean the oven thoroughly with soapy water and rinse well. To remove the lateral frames from smooth-walled Operate the oven for about 30 minutes at maximum temperature to burn off all traces of grease which might otherwise create unpleasant smells when cooking.
Control panel functions Instructions for use Function symbols on the selector Conventional cooking Conventional cooking uses top and bottom heat to cook a single dish. Place the food in the oven only once cooking temperature Top and bottom heating elements. has been reached, i.e.
the fan starts working after approx.10 min. It is turned off when the temperature of the outer shell of the oven descends under 60°C. By switching off the oven with the thermostat at 200°C the fan stops working after approx. 30 min. Thermostat Use the thermostat to set the cooking temperature you need.
itself off. Turn the thermostat and selector knobs back to Minute counter 0 position and press the manual key. Fully automatic operation To set the end of cooking time, press the duration key and press the +/- keys to set the duration of cooking. Press the end of cooking key and press the +/- keys to Fig.
Programming automatic cooking Replacing the oven light IMPORTANT: The oven light must have these precise features: a) it must be able to resist high temperatures (up to 300°C) b) power supply: see V/Hz indicated on data plate. c) power 25W. d) E 14 connection.
Removing the oven door Mod. LO 6014 TC BK, CO 6014 TC X The oven door can be removed quickly and easily. To do so, proceed as follows: - Open the door fully. - Close the door as far as the stop (caused by the raised levers).
The oven can be installed under a work top or in a cooking column. Figure shows the installation dimensions. Make sure that surrounding materials are heat resistant. Align the oven centrally with respect to the side walls of the units surrounding it and it in place with the screws and Allen screws provided.
Electrical connections Before connecting the oven to the mains power supply, make sure that: - The supply voltage corresponds to the on the data plate on the front of the oven. - The mains supply has an earth (ground) connection complying with all applicable laws and regulations.
Page 15
Upon receipt of a valid Claim, a Local Servicing Agent will attend your premises to inspectthe Product. Where a Product is found to be defective, Fulgor Milano Australasia will, at its option and expense, repair or replace the Product or the defective material or part. If Fulgor Milano Australasia repairs or replaces a defective Product, the warranty period for any Product repaired or replaced does not extend beyond the original Warranty Period.
Page 16
If You are unable to provide Proof of Purchase, Fulgor Milano Australasia will not be obliged to repair or replace the defective Product. Fulgor Milano Australasia will not be responsible for any costs or expenses, loss or damage, associated with: Any transport of the Product to a Local Servicing Agent;...
Need help?
Do you have a question about the OV6-10 and is the answer not in the manual?
Questions and answers