Change Thermal Link - ABB Advance Optima Uras 14 Service Manual

Change thermal link

Removing the thermal
link
Installing the thermal
link
Figure 6-12
Analyzer module
Partial view
6-12
To remove the thermal link, proceed as follows:
Step
1 Turn off the analyzer power supply.
2 Open the large door on the analyzer housing.
3 Remove the hood.
4 Remove the thermostat circuit board connector.
5 Pull the thermal link (T) out of the base support.
Essentially the installation process is the reverse of the removal process.
Chapter 6: Component Interchange
Action
SHB_U14