Upper Handle; Screws Taped To Upper Handle; Deep Cleaner Base; Tool Caddy - Bissell 1799 SERIES User Manual

Assembly
WARNING
Do not plug in your deep cleaner until you are familiar with all instructions
and operating procedures.
Your deep cleaner comes in 5
easy-assemble components.

-Upper Handle

-4 Screws Taped to Handle

-Deep Cleaner Base

-Tool Caddy

-2 Hex Nuts

1
First, slide the Upper Handle on to the base.
3
1
1- Place hex nut into back of Tool Caddy and hold in
place. Insert bolt from the front to the back, turning the
bolt into the hex nut until snug. Do not over tighten.
Repeat for the second bolt and hex nut.
www.BISSELL.com
6
The only tool you will need to assemble
your deep cleaner is a Phillips screwdriver.
2
1-From the flat side of the Tool Caddy, feed
the power cord through the rounded-rect-
angle opening.
2-Next, align the Tool Caddy with the Upper
Handle holes.
2
2-Insert 2 screws into
lower 2 holes located
just above the Lower
Hose Rack. Turn the
screws until tight-
ened.
1 2
4
Attach tools to the end of
the hose or front of the
upper handle. Wrap the
power cord and hose.