Minelab x-terra 305 Instruction Manual page 38

Once the approximate target location is
known, move the coil outside of that area
and press Pinpoint
Sweep the coil over the target location. The
menu scale segments on the LCD indicate how
close the target is to the centre of the coil.
The detector will only produce a high volume
when the centre‑ring of the concentric coil is
directly above the target.
Taking note of the detector's response, reduce
the span of each successive pass of the coil
until you are confident of the target's location.
Make a mental note of the position or, if the
ground is sandy, mark a line with your shoe
or a digging tool.
Move to one side so that you can pass the
coil over the target at a right angle to your
initial direction. When the detector sounds you
should know exactly where to dig.
.
1
2
3
4
5
AL
If you have difficulty pinpointing the
target, press Pinpoint/Detect again to
take the detector out of pinpoint and
then return to Step 1.
37