Minelab X-Terra 305 Getting Started Manual

Assembly | Follow the steps to put together your X-TERRA 305
1. Attach coil to lower shaft
1. Insert the two rubber washers into the holes
on either side of the yoke.
2. Slide the yoke into the yoke bracket on top of
the coil.
Ensure that the spring loaded pin in the lower
shaft is underneath.
3. Insert the plastic bolt through the yoke and the
yoke bracket.
4. Fasten with the plastic bolt - Do not
overtighten.
2. Assemble shafts
1. Loosen the twistlocks by rotating them
counter-clockwise.
2. Press the spring loaded pin in the lower shaft
and slide it into the middle shaft until the pin
reaches the adjustment holes. The pin will click
into place.
3. Attach the middle shaft to the upper shaft in
the same way.
4. Lock the position of the shafts by rotating
twistlocks clockwise.
Audio
X-TERRA 305 detectors have an external
loudspeaker for detecting without headphones.
A range of other audio options are available. Please
refer to the full instruction manual for further
information.
3
4
2
1
1
2
3
4
Battery
The X-TERRA uses 4 x AA batteries which are not included with the detector.
1. Access the battery compartment via the battery door located on the side of the control box. Slide the
battery compartment door upwards with your thumb.
2. Place individual batteries into the compartment as illustrated, ensuring the positive (+) and negative (–)
contacts match the diagram on the control box.
3. Close the battery door by pushing and sliding it downwards.
3. Attach armrest/stand
1. Place the armrest onto the top of the upper
shaft. Position the armrest just below your
elbow, then line up the boss in the armrest
with the nearest hole in the shaft.
2. Insert the screw through the stand, upper shaft
and armrest. Tighten the screw carefully.
3. With the velcro side facing upwards, thread
the armrest strap through both slots in the
armrest. Ensure the end of the strap will be
fastened outwards from your arm.
4. Connect control box & coil
1. Push the control box onto the end of the
handle until it fits into place.
2. Wrap the coil cable around the lower and
middle shaft enough times to take up the
slack.
3. Use the velcro tabs provided to secure the coil
cable against the shaft.
4. Align the coil connector and plug into the
socket in the back of the control box, lightly
tightening the retaining ring.
2
1
3
1
3
2
4