Channel List; Add Channels; Optimizing The Signal Quality From Your Antenna - Philips 1EMN26039A User Manual

Channel list

The channels selected here can be skipped when selecting the channels
using CH + / −.
Those channels can still be selected with the Number buttons.
1
Press MENU on the remote control and select [Setup] >
[Channel List].
Picture Picture Autoprogram
Sound Channel List
Setup

Add Channels

Features Antenna
Language
USB
2
Press Î or ï to select the channel you want to remove, then press OK.
Picture Picture
Sound
Setup
Highlight channels for Ch Up/Down key
Features
selection.
Language
USB
Ch Select
• The channel display for the removed channel darkens. You will not
be able to select the channel again using CH + / −.
To reactivate a removed channel, press Î or ï and press OK. The
•
registered channels are highlighted.
• When you remove a major channel, its minor channels are
removed as well.
Note
•
The channel with the [DTV] indicated on the display is ATSC. Otherwise the channel is NTSC.
3
Press MENU to exit.
DTV 40.1
DTV 40.2
DTV 40.3
BACK
Back
Watch/Skip
OK
Add channels
This function lets you add the channels that were not added by the
autoprogram due to the receptible condition at the initial setup.
1
Press MENU on the remote control and [Setup] > [Add Channels].
Picture Autoprogram
Sound Channel List
Setup Add Channels
Features Antenna
Language
USB
2
Press a number (1 to 135) to enter the number of the channel you
want to add, then press OK.
Picture
Sound
For analog channels,
select a channel to be
Setup
added using number keys.
Features
For digital channels,
Language
you must perform
USB
Autoprogram function.
3
Press MENU to exit.
Note
•
If setup completes successfully, [Added to the channel list] is displayed.
•
If external input is used, it is not possible to register the channel and [Unavailable] will
be displayed on the TV screen.
•
By pressing Î or ï you can select the memorized channels only.
•
In most cases, digital channels are not broadcast on the RF channel on which they
appear on your TV. To add digital channels you need to know the RF channel on which
the digital channel is being broadcast. E.g. If there is a digital channel 9.1 which is being
broadcast on RF channel 25, you need to enter 25 while performing a weak channel
installation. To fi nd out the RF channel on which a particular digital channel is being
broadcast, please contact your local service provider.
Installing digital channels using [Add channels] might not work for direct cable
connections and if the digital signal is too weak for the TV to process.
Optimizing the signal quality from your
antenna
You can optimize your signal quality by tuning in ATSC channels with
weak signals, and adjusting the antenna.
1
Press MENU on the remote control and select [Setup] > [Antenna].
2
Press OK to confi rm your choice.
3
Press a number (1 to 135) or press CH + or CH − to select the
channel for which you want to check the digital signal strength.
4
Press MENU to exit.
Add channels
BACK
Back
Ch Change
EN
11
25