Aligning The Blade - Husqvarna MS 360 G Workshop Manual

9
1
3
5
7
9
20
REPAIR INSTRUCTIONS
2
4
6
8

Aligning the blade

First see Check the blade
alignment. (p. 19)
1� Set the saw blade in a low position
to get a good weight balance
of the saw head during the
adjustment�
2� Loosen the 4 screws underneath
the frame that holds the saw head�
3� Move the saw head sideways until
the blade is in the middle of the
cutting slot on the conveyor cart�
4� Adjust the saw head until the
blade is perpendicular to the
conveyor cart anvil� Then tighten
the 4 screws underneath the frame
again�
5� To set the blade perpendicular to
the conveyor cart surface: open
the blade guard to be able to put
an angel against the blade�
6� Loosen the 2 screws underneath
the bearing housing�
7� Loosen the 2 screws on top of the
bearing housing�
8� Use the adjustments screws for the
bearing housing and lock their
positions with the locking nuts�
9� Make sure the blade is
perpendicular to the conveyor
cart surface with an angel before
tightening all bearing housings
screws again�