Assembling The Water Pump - Husqvarna MS 360 G Workshop Manual

1
3
5
7
REPAIR INSTRUCTIONS
2
4
6

Assembling the water pump

First see Renovate the water
pump (p. 15)
NOTE! Always replace all parts
in the renovation kit when
disassembling the water pump.
Sealing, gasket, washers, impeller
and the bearings with the shaft.
1� Use a workshop press to fit the
new spring loaded sealing in the
water pump housing� Use a collar
that presses against the outer
metal parts of the sealing�
2� Use a workshop press to fit the
new shaft with bearing in the
pump housing� The belt pulley
side of the shaft shall go in first.
NOTE! When assembling the new
shaft and bearings, always press on
the outer collar of the bearings to
not damage them�
3� Insert the circlip into the bearing
housing�
4� Put the bearing housing and the
water pump housing together�
NOTE! Do not tighten the screw
until the water pump is mounted
to the saw to get adjustability of
the hose connections�
5� Assemble the two part seal for the
impeller� The plastic washer has a
groove on one side that goes into
the rubber seal� The wear face
should be flat.
6� Fit the 2 new washers on the
impeller shaft�
7� Mount the new impeller�
9
17