Maintenance; Water Pump Trouble-Shooting Procedure; Repairs; Spare Parts - Husqvarna TS 250 XS Operator's Manual

7 MAINTENANCE PROCEDURES
Before performing any maintenance, ALWAYS
place the machine on a level surface with the
motor "OFF" and disconnect the electrical
current. Let the machine cool down!
Your saw is a ruggedly constructed machine, engineered
to give long, satisfactory performance. Simple daily
maintenance and care will add to the life and productivity
of your saw.
After each day's use: CLEAN THE MACHINE!!
•
Turn off and unplug the saw before performing any

maintenance.

•
Keep the cart top clean and free for cuttings. To
clean it, flush the top surface and grooves with
water.
•
Drain, clean and refill the pan frequently. Flush the
coolant system with plenty of water, then drain and
refill the pan.
•
If the water flow stops, check the water pump
to see if the shaft and impeller turn freely. See
the WATER PUMP TROUBLE-SHOOTING
PROCEDURE section below.
•
It is always good practice to clean your tile saw
after each day's use. Drain the water and clean out
the pan. Clean the rails. Before storing, it is good
practice to wipe or spray rails with water-soluble oil
(like, WD-40 or equivalent).
Entrust all repairs to your authorized dealer
only.
8

WATER PUMP TROUBLE-SHOOTING PROCEDURE

If Water Stops Flowing:
1. Stop Sawing, then
2. Disconnect Electrical Plug from Outlet, then
3. Remove the Pump, then
4. Back Flush
Back flushing is done by forcing water into the pump
discharge and out through the screen. Most of the time
this procedure works, and the pump can be put back into
service. (See Figure)
If the back flushing does not work, remove the screen and
turn the impeller manually, looking for and rinsing out the
impeller cavity of any dirt or foreign matter.
WARNING!
9

REPAIRS

We carry out all repairs in the shortest possible time
and at the most economical prices. (See front page for
address and phone numbers) Contact your authorized
dealer concerning maintenance and repairs.
10

SPARE PARTS

For quick supply of spare parts and to avoid any lost
time, it is essential to quote the data on the manufactur-
ers plate fixed to the machine and the part number(s) and
description to be replaced with every order.
The manufacturer accepts no
responsibility caused by unsuitable use or
modifications.
The instructions for use and spare parts found in this
document are for information only and are not binding.
As part of our product quality improvement policy, we
reserve the right to make any and all technical
modifications without prior notice.
WARNING!
7