Preparing The Battery Pack For First Use And Recharging; Attaching The Battery Pack To The Device - Philips DreamStation Go User Manual

• Battery Pack Fault Alert - The display touchscreen will show a battery with an X
inside (shown below) when a battery fault is detected.

Preparing the Battery Pack for First Use and Recharging

1. Remove the battery pack from the packaging.
2. Plug the end of the AC power cord into the battery pack.
3. Plug the AC power cord into an AC outlet. The battery pack will begin to charge au-
tomatically.
4. Once the battery pack is fully charged, it is ready for use with the DreamStation Go
therapy device.
Notes
• Periodically charge the battery pack if not used regularly.
• Retain your packaging in case you ever need to return your battery pack to Philips
Respironics.
• Before using the battery pack for the first time, you must plug it in until it is fully
charged. This may take up to 5 hours.

Attaching the Battery Pack to the Device

After charging, your battery pack is ready to use. It can either be disconnected from the
AC outlet and used as an external battery pack (standalone mode), or remain plugged
into the AC outlet for a continuous, fully charged battery pack (uninterruptible power
supply (UPS) mode).
To use the battery pack in UPS mode, follow the below steps:
1. Keep the battery pack plugged into the power source and connected to an AC
outlet. This will allow you to use the battery pack continuously without losing any
charge.
7. Battery Pack
35