Practical Applications - Hitachi C 15 FB Handling Instructions Manual

2. Installation of holder (Fig. 4)
The holders are to make the workpiece stable.
Install them on the right and left sides of the base and
fi x them with 10 mm bolts.
For moving the holders, loosen the 10 mm bolts.
3. Cutting of workpiece of fi xed length (Fig. 5)
For cutting many workpiece of the same length, it is
convenient if the stopper is used.
When installing the stopper, fi x it with the 6 mm wing
bolt onto the holder.
4. Handle position adjustment (Fig. 6)
During cutting operation, adjusting the upper limit
adjustment bolt according to workpiece height as
illustrated in Fig. 6 reduces the up-down handle
motion range for a higher operating effi ciency.
Loosen the 10 mm lock nut which fi xes the upper limit
adjustment bolt and move the handle up and down to
allow the adjustment bolt to be set in a position fi t to
the height of the workpiece to be cut. Then fi x the 10 mm
lock nut.
5. Ink line matching operation (Fig. 7)
For cutting along a ink line marked on the workpiece,
operate the lever located on the handle side of the saw
cover as illustrated in Fig. 7 to lift the lower guard and
align the saw blade with the ink line before starting
cutting operation.
CAUTION
Take care never to operate the lever while the saw
blade is rotating.

PRACTICAL APPLICATIONS

CAUTION
It is dangerous to remove or install the workpiece while the saw blade is turning.
1 Switch operation
After pushing the lock-off button with the thumb, the tool is turned ON when the switch
trigger is pulled, and OFF when the trigger switch is released.
Holder
10 mm Bolt
27
English
10 mm Bolt
Fig. 4
Stopper
6 mm Wing Bolt
Fig. 5
Fig. 6
Lever
Fig. 7