Care And Cleaning; Cleaning The Hob; Troubleshooting; What To Do If - Electrolux EHL7640FOK User Manual

It may happen that other
remote controlled appliances
may block the signal. To
avoid it do not operate the
remote of the appliance and
the hob at the same time.
Cooker hoods with the Hob²Hood
function

6. CARE AND CLEANING

WARNING!
Refer to Safety chapters.
6.1 General information
• Clean the hob after each use.
• Always use cookware with clean
bottom.
• Scratches or dark stains on the
surface have no effect on how the hob
operates.
• Use a special cleaner applicable for
the surface of the hob.
• Use a special scraper for the glass.

6.2 Cleaning the hob

• Remove immediately: melted plastic,
plastic foil, and food with sugar. If not,

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.

7.1 What to do if...

Problem
You cannot activate or op‐
erate the hob.
To find the full range of cooker hoods
which work with this function refer to our
consumer website. The Electrolux cooker
hoods that work with this function must
have the symbol
the dirt can cause damage to the hob.
Put the special scraper on the glass
surface at an acute angle and move
the blade on the surface.
• Remove when the hob is
sufficiently cool: limescale rings,
water rings, fat stains, shiny metallic
discoloration. Clean the hob with a
moist cloth and non-abrasive
detergent. After cleaning, wipe the
hob dry with a soft cloth.
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is blown.
ENGLISH
.
Remedy
Check if the hob is correct‐
ly connected to the electri‐
cal supply. Refer to the
connection diagram.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
15