Electrolux EHL7640FOK User Manual page 16

16 www.electrolux.com
Problem
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
The hob deactivates.
Residual heat indicator
does not come on.
Hob²Hood function does
not work.
Automatic Heat Up func‐
tion does not operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no signal when
you touch the panel sensor
fields.
comes on.
comes on.
Possible cause
You touched 2 or more
sensor fields at the same
time.
STOP+GO function oper‐
ates.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
You put something on the
sensor field .
The zone is not hot be‐
cause it operated only for a
short time.
You covered the control
panel.
The zone is hot.
The highest heat setting is
set.
Power management func‐
tion operates.
The cookware is too large
or you put it too near to the
controls.
The signals are deactiva‐
ted.
Automatic Switch Off oper‐
ates.
The Child Safety Device or
the Lock function operates.
Remedy
Activate the hob again and
set the heat setting in less
than 10 seconds.
Touch only one sensor
field.
Refer to "Daily use" chap‐
ter.
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
If the zone operated suffi‐
ciently long to be hot,
speak to an Authorised
Service Centre.
Remove the object from
the control panel.
Let the zone become suffi‐
ciently cool.
The highest heat setting
has the same power as the
function.
Refer to "Daily use" chap‐
ter.
Put large cookware on the
rear zones if possible.
Activate the signals.
Refer to "Daily use" chap‐
ter.
Deactivate the hob and ac‐
tivate it again.
Refer to "Daily use" chap‐
ter.