Electrolux EHL7640FOK User Manual page 31

Problem
The Automatic Heat Up
function does not oper-
ate.
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no signal when
you touch the panel sen-
sor fields.
comes on
comes on
comes on
and number comes
on.
Possible
The cooking zone is hot.
The highest heat setting
is set.
The Power management
is activated.
The cookware is too large
or you put it too near to
the controls.
The signals are deactiva-
ted.
The Automatic Switch Off
operates.
The Child Safety Device
or the Lock function op-
erates.
There is no cookware on
the cooking zone.
The cookware is incor-
rect.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
The cookware does not
cover the cross.
There is an error in the
appliance.
ENGLISH
Remedy
Let the cooking zone be-
come sufficiently cool.
The highest heat setting
has the same power as
the Automatic Heat Up
function.
Refer to "Power manage-
ment".
Put large cookware on
the rear cooking zones if
necessary.
Activate the signals. Refer
to "OffSound control".
Deactivate the appliance
and activate it again.
Refer to the chapter "Dai-
ly Use".
Put cookware on the
cooking zone.
Use the correct cook-
ware.
Use cookware with cor-
rect dimensions.
Cover the cross / square
fully.
Disconnect the appliance
from the electrical supply
for some time. Discon-
nect the fuse from the
electrical system of the
house. Connect it again.
If comes on again,
speak to the service cen-
tre.
31