Specifications - Makita GD0800C Instruction Manual

ENGLISH (Original instructions)
1-1. Slide switch
2-1. Speed adjusting dial

SPECIFICATIONS

Max. wheel point diameter
Rated speed (n) / No load speed (n
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding ferrous materials or
deburring castings.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Model GD0800C
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Model GD0810C
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Explanation of general view
3-1. Side handle
4-1. Wrench 19
Model
Collet size
)
0
Overall length
Net weight
Safety class
noise level determined
) : 78 dB(A)
pA
) : 79 dB(A)
pA
GD0800C
8 mm max.
25 mm
28,000 (min
371 mm
1.7 kg
ENE050-1
Vibration
The vibration
determined according to EN60745:
ENF002-2
Model GD0800C
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
If the tool is used for other applications, the vibration
values may be different.
ENG905-1
Model GD0810C
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
vibration emission value may be different.
WARNING:
The vibration emission during actual use of the power
•
tool can differ from the declared emission value
depending on the ways in which the tool is used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
4-2. Wrench 13
4-3. Collet nut
GD0810C
8 mm max.
50 mm
-1
) 7,000 (min
371 mm
1.7 kg
/II
total value (tri-axial
) : 2.5 m/s
h,AG
2
) : 2.5 m/s
h,SG
2
-1
)
ENG900-1
vector sum)
2
2
or less
ENG902-1