Enabling And Disabling Parksense; Service The Parksense Park Assist System - Chrysler PACIFICA 2017 Owner's Manual

Hide thumbs Also See for PACIFICA 2017:

Table of Contents

384 STARTING AND OPERATING

Enabling And Disabling ParkSense

ParkSense can be enabled and disabled with the ParkSense

switch, located on the switch panel below the Uconnect

ParkSense Switch

When the ParkSense switch is pushed to disable the

"PARKSENSE OFF" message for approximately five sec-

onds. Refer to "Instrument Cluster Display" in "Getting To

Know Your Instrument Panel" for further information.

When the gear selector is moved to REVERSE and the

system is disabled, the instrument cluster display will

show the "PARKSENSE OFF" message for as long as the

vehicle is in REVERSE.

The ParkSense switch LED will be ON when ParkSense is

disabled or requires service. The ParkSense switch LED

will be OFF when the system is enabled. If the ParkSense

switch is pushed, and requires service, the ParkSense

switch LED will blink momentarily, and then the LED will

NOTE: When KeySense feature is present, the ParkSense

System will reject customer input to turn the system OFF

via the hard switch. The instrument cluster display will

show KeySense in Use Selected Feature Cannot be Dis-

abled message.

During vehicle start up, when the ParkSense System has

detected a faulted condition, the instrument cluster will

actuate a single chime, once per ignition cycle, and it will

display the PARKSENSE UNAVAILABLE WIPE REAR

SENSORS , PARKSENSE UNAVAILABLE WIPE FRONT

SENSORS , or the PARKSENSE UNAVAILABLE SERVICE

REQUIRED message for five seconds. When the gear

selector is moved to REVERSE and the system has detected

a faulted condition, the instrument cluster display will

Table of Contents