Set And Display Cost/Kwh / Display Metering Functions - brennenstuhl PM 231 E Operating Instructions Manual

PM 231 E Operating instructions
GB
Now connect the appliance and turn it on. The power
meter starts measuring the consumption.
5.4.2 Set and Display Cost/kWh / Display Metering
Functions
Set and Display Cost/kWh
If VOLTAGE / AMP / WATT appears on the display, press
and hold the FUNC button (6) for at least 2 seconds until
Cost/kWh (16) is shown. If already 2 prices were
entered these can be displayed in turn by pressing the
FUNC button (6).
Set Cost/kWh (Price 1)
Press and hold the SET button (5) until the fi st digit fl ashes
to set the cost/kWh after the cost/kWh for price 1 (18) are
displayed. Set the correct value for the fi rst digit with the
UP button (4). Now press the SET button (5) again until
the second digit fl ashes and set the correct value with the
UP button (4). Repeat the procedure for the third and the
fourth digit.
You can move the decimal point by pressing the SET
button (5) to start fl ashing and move it with the UP button (4)
to the correct position.
29