Technical Data; Installation - Electrolux ENN28600 User Manual

10 electrolux
Problem
The appliance does not
work at all. The appli-
ance does not cool at all.
Neither cooling nor light-
ing works
Replacing the bulb
If you want to replace the bulb, do these
steps:
1. Break the circuit of the appliance.
2. Press on the rear hook and at the same
time slide the cover in the direction of
the arrow.
3. Replace the bulb with one of the same
power and specifically designed for
household appliances. the maximum
power is shown on the light bulb cover)
4. Replace the light cover by sliding it into
its original position.
5. Reconnect the appliance.
6. Open the door and check if the light
comes on.

TECHNICAL DATA

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Possible cause
The appliance may be switched
off
Plug is not connected to the
mains socket properly
Power does not reach the appli-
ance
There is no voltage in the mains
socket (try to connect another
appliance into it)
Height
Width
Depth
Switch on the appliance
Connect the mains plug properly
Try connecting another electrical
device to the power outlet
Call an electrician
1780 mm
560 mm
550 mm
13 h
230-240 V
50 Hz
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
Solution