Installation - Electrolux ENN2801EOW User Manual

Problem
All the temperature setting
LEDs flash at the same
time.
7.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your After Sales
Service.

8. INSTALLATION

8.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
SN
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
Ambient temperature
+10°C to + 32°C
Possible cause
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
The FastFreeze function is
switched on.
There is no cold air circu-
lation in the appliance.
An error has occurred in
measuring the tempera-
ture.
7.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective
Climate
class
N
ST
T
Solution
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Refer to "FastFreeze func-
tion".
Make sure that there is cold
air circulation in the appli-
ance.
Contact the nearest Author-
ized Service Centre. The
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible.
"Installation".
door gaskets. Contact the After Sales
Service.
Ambient temperature
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
ENGLISH 13