Draining The Brewer; High Altitude Use; Authorized Service - Bunn A-10 Manual

Hide thumbs Also See for A-10:

Installation & operating manual (15 pages)

Illustrated parts catalog (14 pages)

Use and care manual (12 pages)

Table Of Contents

Table of Contents

The water in your Bunn

on a trip, shipped, or stored in an unheated location with a chance of freezing.

1) Unplug the brewer and cool the hot water in the tank.

Place the empty decanter on the warmer. Simply pour a

full water pitcher of cold water into the top of the brewer,

close the lid and wait for the water to stop flowing from

the funnel. Empty the decanter, repeat. This will cool the

water in the tank.

2) Remove sprayhead by turning counterclockwise with your

fingertips and set it aside.

3) Grasp the back of the brewer and quickly turn it upside

down over a sink as shown. Most of the water in the tank

will flow from the sprayhead opening but some water

may flow from the area around the top lid. Continue tip-

ping the brewer until the flow of water ceases.

4) Reinstall the sprayhead when all water has drained from

the brewer. Securely tighten it by turning clockwise.

NOTE - Refer to PREPARING THE BREWER FOR

USE before using the brewer.

Your Bunn Pour-Omatic

the country. For high altitude use, over 5000 feet, the model A10-D should be used.

For service (whether or not warranty is still in effect), drain the brewer, carefully

pack it so it is fully protected against breakage and send it to one of the authorized

Bunn-O-Matic facilities listed below:

Bunn-O-Matic Corporation

Retail Products Division

1400 Stevenson Drive

Springfield, Illinois 62703

(800) 352-2866