Table of Contents
Advertisement
December 21st, 1995
G4 Communication Parameters *
Compression
mode
Resolution
Width and
reduction
Transfer
Confidential
Other
parameters
System Switch 01
No
FUNCTION
PM call
0: Disabled
0
1: Enabled
1-7 Not used
System Switch 02
No
FUNCTION
Memory file transfer
0: Disabled
1: Enabled
0
MMR: MMR compression
MR: MR compression
MH: MH compression
21: Standard (200 x 100 dpi)
22: Detail (200 x 200 dpi)
24: Fine (200 x 400 dpi)
A4: A4 (8.3"), no reduction
B4: B4 (10.1"), no reduction (tx only)
A3: A3 (11.7"), no reduction (tx only)
T: Transfer
- : Other
C: Confidential
- : Other
The following information is shown in 6-bit format. Bit 1 is the first bit
from the left, and bit 6 is at the right end.
Bit 1 - Smoothing
(Smoothing is disabled in halftone mode.)
Bit 2 - CIL printing
Bit 3 - 1: Not used
Bit 4 - mm/inch conversion
Bit 5 - Engine type
Bit 6 - Resolution unit
This bit switch determines whether the machine will
send an Auto Service Call to the service station when it
is time for PM.
Cross reference
Auto service calls: Section 2.3.2
Do not change the settings.
1: All messages in the memory (including confidential
rx messages) are sent to the fax number which is
programmed as the service station.
Always reset this bit to zero after transfer.
Cross reference
Service station number programming: Function 13
SERVICE TABLES AND PROCEDURES
0: Enabled, 1: Disabled
0: Enabled, 1: Disabled
0: Disabled, 1: Enabled
0: mm, 1: inch
0: mm, 1: inch
COMMENTS
COMMENTS
4-27
BIT SWITCHES
Advertisement
Table of Contents
