Table of Contents
Advertisement
FOCUS OR FLANGE-BACK ADJUSTMENT
The following adjustment should be made by qualified
service personnel or system installers.
1. Loosen the screw on the side of the camera.
2. Turn the flange-back adjusting ring to the desired
position.
Caution: When the C-mount lens is mounted, do
not rotate the ring counterclockwise by force
after it stops. If the ring is rotated by force,
the inner lens or CCD image sensor may be
damaged.
3. Tighten the screw on the side of the camera.
Caution: Tightening the screw by force will cause
damage to the screw or deviation of focus.
Focusing of
CS-mount lens
Screw
-13-
Focusing of
C-mount lens
Flange-back
Adjusting Ring
Advertisement
Table of Contents
