Table of Contents
Advertisement
SETTING PROCEDURES
1. Camera Identification (CAMERA ID)
Setting
You can use the camera identification (CAMERA ID) to
assign a name to the camera. The camera ID consists
of up to 16 alphanumeric characters. The camera ID
display can be switched on or off on the monitor
screen.
To edit the CAMERA ID
1. Move the cursor to the CAMERA ID parameter.
2. Press I. The CAMERA ID menu appears. The
cursor on the letter "0" is highlighted.
3. Move the cursor to the character you want to edit
by pressing L/M/J/K.
Character Cursor
0123456789
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
().,'":;&#!?=
+-*/%$ÄÜÖÆÑÅ
SPACE
POSI RET END RESET
................
Pointer
CAMERA ID menu
4. After selecting the character, press I.
5. Repeat the steps above until all characters are
To enter a blank space in the CAMERA ID
Move the cursor to SPACE and press I.
To replace a specific character in the CAMERA ID
1. Move the cursor to the editing area by pressing
2. Move the pointer to the character to be replaced
3. Press I to determine the CAMERA ID.
To erase all characters in the editing area
Character
Area
Move the cursor to RESET and press I. All charac-
ters in the editing area disappear.
Command
Editing
Area
-22-
selected character appears in the editing area.
(The pointer in the editing area moves to the right
automatically at this moment.)
edited.
K.
by pressing L or M. Then move the cursor to
the character area and select a new character.
The
Advertisement
Table of Contents
