Table of Contents
Advertisement
PREMIER QUATRO ZT-TSRI Installation Manual
2.4 Connections to Web Server
There are two options to access your Web Server:
1.
Connect the ZT-TSRI directly to a PC via RJ-45 connectors through an Ethernet cable.
2.
Connect the Repeater to a LAN (via Ethernet connection) and access from any PC
connected to it. If there is server active DHCP on the network, the equipment will auto
configure your network options (whenever this option is operational). See section
2.5 Connection Checks & Start-up
Before powering up the ZT-TSRI, double check that all the connections are correct, then turn on
the power. The repeater will take around 30-40 seconds to boot when turned on. Once it has
booted, it will load into its main repeater screen:
If the repeater is connected and communicating to the Quatro panel correctly, the "CONNECTION
WITH PANEL ON" digital LED will be GREEN. If there is a connection issue, this digital LED will be
shown in YELLOW. If connection problems do arise then make sure the system settings are correct.
3. General
The digital repeater is a peripheral based on an embedded system to which the customer can
connect any screen with HDMI input.
3.1 Function
Main panel repeater: Indicates
Shows the location of Zones that are affected by events on a map/plan.
Shows the location of devices that are affected by events on a map/plan.
Has the remote function to: Reset, Silence Buzzer, Silence Sounders and Start Sounders.
Doc No: GLT-281-7-1
alarms
and
faults
associated with zones.
Issue: 1.1
Author: TE
Firmware Version: 2_0z3
5
DATE: 16/11/2016
Advertisement
Table of Contents
