Table of Contents
Advertisement
PREMIER QUATRO ZT-TSRI Installation Manual
Firmware Version: 2_0z3
1. Introduction
1.1 System Planning and Design
It is understood that the system, of which this device is part, has been designed by an expert in
fire alarm systems, and is in accordance with the requirements of British Standard BS 5839-
1:2013 and other applicable standards. The design should clearly show the locations of the
control panel and field devices.
1.2 Personnel
Installation of this product should only be carried out by qualified personnel. Read the setup and
startup procedures in this manual carefully. The manufacturer recommends checking the cabling
before making any connection to the equipment. Do not perform any configuration without fully
understanding how it functions.
2. Setup
2.1 Connecting the Power
The ZT-TSRI is powered by 5v, and is provided with a 5v micro (mini) USB power supply. The
power supply is to be plugged into the micro USB port, positioned to the left of the HDMI port.
2.2 Connections to the Quatro Panel
The ZT-TSRI will connect to the QT-NC Modbus via the provided USB A to Serial converter.
NOTE: To avoid an earth fault on you panel due to a connection to a TV/Monitor, please
purchase the following: (RS Stock No.912-0459)
http://uk.rs-online.com/web/p/pc-data-
acquisition/9120459/
The ICP-DAS Isolated Converter will isolate the RS485 from the repeater, and the RS485 on the
network card, so that no Earth Fault will be given from the connected display. We recommend
that one is used to ensure that your panel is able to detect other Earth faults that may occur in
the panel/loops.
3
Doc No: GLT-281-7-1
Issue: 1.1
Author: TE
DATE: 16/11/2016
Advertisement
Table of Contents
