ELNA 7200 Service Manual page 15

7200
ADJUSTMENT OF DIRECTION OF PRESSER BAR AND ITS HEIGHT
WHEN THE PRESSER FOOT IS LIFTED, THE DISTANCE BETWEEN THE SURFACE OF THE
NEEDLE PLATE AND THE BOTTOM OF THE ZIGZAG FOOT SHOULD BE 6 MM AS SHOWN IN
FIG. 1. WHEN THE PRESSER BAR IS LOWERED, THE PRESSER FOOT SHOULD BE
PARALLEL WITH THE SLOTS FOR THE FEED DOGS AS SHOWN IN FIG. 2.
HEXAGONAL SOCKET SCREW (A)
PRESSER BAR LIFTED
FIG. 1
ZIGZAG FOOT
SLOTS FOR FEED
FIG. 2
DOGS
HEXAGONAL
SOCKET
SCREW (A)
6 MM
TO BE PARALLEL
WITH SLOTS FOR
FEED DOGS
14
[TO ADJUST]:
1 REMOVE THE FACE PLATE (REFER TO PAGE 1)
2 LIFT THE PRESSER BAR.
LOOSEN THE HEXAGONAL SOCKET SCREW (A).
ADJUST THE DIRECTION AND HEIGHT OF THE
PRESSER BAR.
3. ATTACH THE FACE PLATE.