Processing Panel For A Control Box Or Cabinet; Using The F940Got Handy - Mitsubishi F940GOT Handy Series Hardware Manual

F940GOT Handy Series
3.4

Processing Panel for a Control Box or Cabinet

3.4.1

Using the F940GOT Handy

1) Installing a connector on the panel of a control box or cabinet.
Connect to an FX/A/QnA Series PLC using a relay cable for connection to PLC as shown
below. Further information regarding applicable PLCs can be found in GOT-F900 Series
Hardware Manual.
F 9 4 0 G O T H a n d y
P O W E R
a) External cable (with 25-pin D-sub male connector)
Table 3.3: External Cable
Model Name
F9GT-HCAB-3M
F9GT-HCAB-10M
b) Relay cable for connection to PLC
Table 3.4: Relay Cable
Model Name
F9GT-HCAB2-150
F9GT-HCAB3-150
Note:
When connecting to a port or unit other than the programming port of an FX, A or QnA
series PLC, make a cable corresponding to the configuration of the communications port in
question. Or use F9GT-HCAB1-**M external cable. For allocation of Handy GOT
communication signals, refer to section 3.2.
C o n t r o l p a n e l o r
o p e r a t i o n p a n e l
b )
G R I P S W
a )
3m (9' 10")
10m (32' 9")
Length
1.5m (4' 11")
P L C
Length
FX Series (FX , FX
0
FX (FX, FX ), A, QnA Series
2C
Applicable
, FX , FX , FX , FX
0S 0N 1S 1N
Installation 3
, FX )
2N 2NC
3-9