Upgrade The Software Through The Cablewizard 2 - InFocus 900 Series Service Manual

NOTE If you can't find the file, use the Windows Find feature to locate the file. On the Tools menu,
point to Find, then click Files or Folders. In the Find dialog box, enter the name of the file (for
example, 920v1.0.exe).
5 To extract the files, click Unzip. Then click Close.
6 The upgrade files appear in the folder you specified. Now you're ready to upgrade the software in
the projector.

Upgrade the software through the CableWizard 2

You can use this upgrade method when the projector rests on a bench or is otherwise close at hand. If
the projector is mounted on the ceiling or in a rear projection booth, use the RS-232 connection to flash
the projector.
Besides the CableWizard 2, you need one of the following cables:
♦
serial download cable PN 210-0107-00 (see directions on page 52))
♦
serial download cable PN 210-0087-00 (see directions below)
Connect the projector to the computer with the 210-0087-00 cable
1 Turn the selector on the CableWizard until Mac appears in the CableWizard window.
2 Plug the PS/2 end of the serial cable into the mouse connector on the CableWizard.
3 Plug the other end of the serial cable into the Communication Port 1 (COM1) on the computer.
4 Connect the CableWizard connector to the CableWizard port on the projector I/O panel.
NOTE If needed, you can attach the serial cable to COM2. These instructions address use of either
serial port.
5 Plug the power cord into the projector and into a power source.
6 Now you're ready to upgrade the software(see page 52).
LP900 Series Service Manual 51