Installation - ESP Ecocent 100L Installation And Operation Manual

• In areas where the water contains a high proportion of solids, e.g.
suspended matter that could block the strainer, unless adequate
filtration can be ensured.
• Where another appliance in the room is vented by way of an open flu.
The installation must be carried out in accordance with the relevant
requirements of:
A) The appropriate Building Regulations: either The Building
Regulations (England and Wales), The Building Regulations (Scotland) or
Building Regulations (Northern Ireland).
B) The Water Fittings Regulations (England and Wales) or Water By-laws
(Scotland).
C) Any other applicable Regulations.
Failure to observe any of the above conditions will invalidate the
warranty/guarantee.
4.5 Package Contents
Where the unit is to be installed as an unvented system it will be supplied
with the fittings needed to allow installation to comply with G3 Regulations –
This means that the supply cost for the unvented configuration unit will be
higher than when installed as a vented system as additional fittings are
required. Where the unit is to be installed in a vented system, such fittings
will not be necessary.
www.esavep.com
14 of 42
V 1.9
PASHW-003-100LD