Setting Date And Time - schwa-medico TENStem eco basic Instruction Manual

Connecting the cables to the TENStem eco basic
Connect the white plug at the other end of the cable to the
sockets on the upper front face of the TENStem eco basic (no.
6). You may use the device with one or two cables depending
on the therapy.
Switching ON the TENStem eco basic
Press to switch ON the TENStem eco basic. A double beep
sounds. The display indicates the selected program, the
therapy time, the frequency, the pulse width and the intensity.
Selecting a program
Press P until you have selected the program of your choice.
Once you have reached P15 you will return to P1.
Starting the stimulation / setting the intensities
Press the left key to increase the intensity of channel 1.
Press the right key to increase the intensity of channel 2.
Press the left key to reduce the intensity of channel 1.
Press the right key to reduce the intensity of channel 2.
It is not possible to adjust the intensity of both channels at the
same time.
Stopping the stimulation
The stimulation stops automatically at the end of each program. You can stop the
stimulation manually at any time by pressing the
Switching OFF the device
Press the key to switch OFF the device. A single beep sounds. The TENStem eco basic
switches OFF automatically after 2 minutes if no key pressed.

Setting date and time

Before you can use the memory query mode you need to set the date and time.Pressing
and holding the E key for about 3 seconds leads you to the date/time mode. In date/
time mode the LCD shows two figures: The left figure indicates the date, the right
figure indicates the time. Pressing the left
Pressing the left key decreases the date by one day (min. 1).
P key or the
key increases the date by one day (max. 30).
English
Program ON/OFF Stop
Intensity Intensity
Channel 1 Channel 2
key.
9