Safety; Malfunction And Remedy (Faq) - ALDI GLEKS 2440 User Manual

Electric Impact Shredder – GLEKS 2440

Safety

The shredder has a safety switch
The control unit for it
If the loading tunnel is not perfectly positioned or if it is not pressed against the motor
housing, the safety switch will trip and prevent the motor from working. If this situation
occurs, open the loading tunnel as described above. Carefully clean the interior. Close the
loading tunnel again as described above and ensure that when you switch on the machine
again the loading tunnel is correctly positioned and the safety screw is screwed right in.
NEVER undo the release screw
switching off the machine at the ON/OFF switch
disconnecting the shredder 13A plug.

Malfunction and remedy (FAQ)

Problem
The machine
does not work
Shredding
performance
unsatisfactory
AFTER SALES SUPPORT
0151 649 1500
66926_3430345_11026_ug_inner.indd 39
A
7 (Fig. 12c) is located on the inside of the loading tunnel.
CAUTION!
Problem Cause
No power at the plug
Machine is switched off
Overload switch has tripped
Ejector chute is blocked
Loading tunnel is not
secure on the motor
housing
Blades worn
1890 946244
(Fig. 12b) in its interior on the motor housing.
(Figure 12a) without first
12
Corrective Action
Check the power at the plug cable and fuse
Switch on machine
Set the On/Off switch to the position 'I' to
start or restart the electric motor
Clean ejector chute
Clean interior and tighten safety screw
Turn, sharpen or replace blades
Use
(Figure 11) and
11
39
www.einhell.co.uk
22/03/2016 3:22 pm