Problems And Solutions For Programmed Recordings - Philips VR507 User Manual

PROBLEM
The video recorder
will not operate
'SWITCH TO
STANDBY- TIMER
RECORDING' flashes on
the TV screen
Cassette is ejected
during recording
Error message: 'NO
CASSETTE'
' will flash
k
in the video recorder
display
Cassette was ejected
as soon as the
button was pressed
OK
Error message: 'ALL
TIMERS OCCUPIED'
Programming a recording (TIMER)
Problems and solutions for programmed
recordings
SOLUTION
b
While a programmed recording is being made, you cannot operate your video recorder manually.
If you want to cancel the programmed recording, press STANDBY/ON m .
b
The video recorder was switched on several minutes before the start of a programmed recording.
Switch off the video recorder with STANDBY/ON m . A programmed recording (timer) will
only function if the video recorder is switched off.
b
The end of the tape was reached during recording.
b
No cassette was inserted. Insert a cassette and switch off the video recorder using
STANDBY/ON m .
b
A cassette was inserted with the security tab removed. Undo the erase protection (chapter
'Manual Recording', section 'Preventing accidental erasing of cassettes') or insert a different
cassette.
b If this error message appears after pressing TIMER k , then all TIMER blocks are already
programmed. No more recordings can be programmed. If you want to clear a programmed
recording (TIMER block), select it with P ;q or P =r and then press CLEAR (CL) .
35