Recording With Automatic Switch-Off (Otr One-Touch-Recording); Preventing Accidental Erasing Of Cassettes; Lining Up Recordings (Assemble Cut) - Philips VR507 User Manual

28
Recording with automatic switch off
(OTR One Touch Recording)
1
Insert a cassette.
2
Use P ;q or P =r to select the programme number you want to
record.
3
Press RECORD n on the remote control.
4
Each time you press RECORD n you will add 30 minutes to the
recording time.
How can I clear the recording time just setted?
To delete an entry, press
recording time.

Preventing accidental erasing of cassettes

All cassettes (except for rental and store cassettes) have a security tab on the back of the
cassette (see arrow).
To prevent recording over important recordings (erasing), you can remove this security tab or
slide it to the left.
If you later decide to record on a protected cassette, simply cover the hole with adhesive tape
or slide the tab to the right.

Lining up recordings (assemble cut)

When you add a further recording to a cassette, which already has a recording on it, a short
blank (flicker) can appear between the old and the new recording or the picture itself can flicker.
To help reduce these from occurring, proceed as follows:
1
Find the tape position of the old recording where you want to insert
the new recording.
2
Look at the last minute of the old recording (playback).
3
Press STOP h on the remote control at the tape position where the
new recording is to go. 9 ' will appear on the display.
4
Now start recording as usual by pressing RECORD n on the remote
control.
5
Stop recording with STOP h .
CLEAR (CL)
while the display shows the
Manual recording