Table of Contents
Advertisement
1. Remove the battery.
2. Remove the 5 screws and then the rear panel.
Screws (S1)
Discharging
Condenser is the device to store electric energy. Hundreds of high voltage is required when strobo emits
light. It has a lot of risk to get electric shocked if you touch the condenser when it stores electric energy. Be
sure to discharge the condenser, before start of disassembling.
Note: Discharge with discharging pads on the strobo PCB.
To avoid shoring with the frame while discharging, provide protection such as putting the insulating tape.
Discharging pad (Minus)
Discharging pad (Plus)
e [ v
DISASSEMBLY
Screw (S1)
Insulating tape
NG
— 19 —
Screws (S1)
Advertisement
Table of Contents
