Trill Configuration Example; Network Requirements - HP 5920 Series Configuration Manual

Task
Display information about the TRILL
VR unicast FIB.
Display the TRILL VR multiport unicast
MAC address table.
Clear dynamic running statistics of
the TRILL process.

TRILL configuration example

Network requirements

As shown in
the access layer. A port connected to a higher layer device is an uplink port, and a port connected to a
lower layer device is a downlink port.
Configure TRILL in the network as follows:
Enable TRILL on both uplink and downlink ports of access layer devices, and enable TRILL on
•
downlink ports of distribution layer devices.
Configure two TRILL distribution trees that are rooted at RB 1 and RB 2. Configure a higher priority
•
for RB 1 to be a distribution tree root.
Configure a TRILL VR and multicast routing for the TRILL network to forward Layer 3 traffic.
•
Figure 8 Network diagram
Figure 8, a data center network has three layers: the core layer, the distribution layer, and
Command
display trill vr-fib [ count | mac mac-address vlan vlan-id ]
display trill vr-route [ vrid vrid ] [ vlan vlan-id ] [ mac-address
mac-address ]
reset trill
25