Configuring Snmp For Trill; Enabling Trill To Forward Traffic From Evb S-Channels - HP 5920 Series Configuration Manual

To enable logging of TRILL neighbor changes:
Step
1. Enter system view.
2. Enter TRILL view.
3. Enable logging of TRILL
neighbor changes.

Configuring SNMP for TRILL

To report critical TRILL events to an NMS, enable SNMP notifications for TRILL. For TRILL event notifications
to be sent correctly, you must also configure SNMP as described in Network Management and
Monitoring Configuration Guide.
TRILL shares the standard IS-IS MIB with IS-IS. The standard IS-IS MIB provides only single-instance MIB
objects. For SNMP to correctly identify TRILL's management information in the standard IS-IS MIB, you
must configure a unique context for TRILL.
Context is a method introduced to SNMPv3 for multiple-instance management. For SNMPv1/v2c, you
must specify a community name as a context name for protocol identification.
To configure SNMP for TRILL:
Step
1. Enter system view.
2. Enable SNMP
notifications for TRILL.
3. Enter TRILL view.
4. Configure the context
name for TRILL.
Enabling TRILL to forward traffic from EVB
S-channels
Perform this task on the interface that is directly connected to a server. TRILL will forward the packets
received from the EVB S-channels on the interface to the TRILL network.
Before you perform this task, you must enable EVB on the interface.
To enable TRILL to forward traffic from EVB S-channels:
Command
system-view
trill
log-peer-change enable
Command
system-view
snmp-agent trap enable trill
[ adjacency-state-change | area-mismatch |
buffsize-mismatch | id-length-mismatch |
lsdboverload-state-change | lsp-parse-error |
lsp-size-exceeded | max-seq-exceeded |
maxarea-mismatch | new-drb | own-lsp-purge
| protocol-support | rejected-adjacency |
skip-sequence-number | topology-change |
version-skew ] *
trill
snmp context-name context-name
22
Remarks
N/A
N/A
By default, logging of TRILL neighbor changes
is enabled.
Remarks
N/A
By default, SNMP
notifications are enabled for
TRILL.
N/A
By default, no context name
is configured for TRILL.