Custom Folds; General Set Up; Fold Measurements And Settings; Adjustments - Hedman HF-400 Operating Manual

HF-400
Operating Manual
38. Fold Length Indicator
Inch
Scale
LETTERHEAD
First
Measurement
Trailing Edge
First
Measurement
Trailing Edge
Zig-Zag Fold
Second Fold
Measurement
First Fold
Letter Fold
First Fold
Measurement
Second Fold

Custom Folds

The HF-400 can be used to fold a variety of
sheet lengths and widths into the preset fold
types or into variations of them.
All custom folds are set up by first folding a
sample sheet into the desired fold, then meas-
uring two distances:
1. From the leading edge to the first fold.
2. From the first fold to the second fold.
(See page 17 for folding sequences)
38
These distances are then set using the inch
scales on the fold tables. In the illustration,
the indicator (38) is set at 8.5".
Second
The dimension of the first fold should be set
on the first fold table (to the right) and the
second on the second fold table (to the left).
Two measurement examples are illustrated.
Make fine adjustments to the fold lengths in
the same way as described for standard folds
(see page 16).
NOTE
Treat a single fold as if it were the second fold.
Set the indicator on the first fold table all the
way down to the single fold icons. Then set
Second
the dimension to the fold on the inch scale on
the second fold table.
19
Rev. 12/04
Cusom Folds