Set Up; Support; Power; Feed Table Extension - Hedman HF-400 Operating Manual

HF-400
Operating Manual

6. Feed Table Extension

7. Feed Table Extension Latch
(pull to release)
9. Power Cord Socket
10. Fuse Drawer
11. Main Power Switch
32. Long Paper Support
11
7

Support

Place the HF-400 on a solid table or stand in a
position where the operator has access to both
ends of the machine as well as to the operator
side of the machine.
WARNING
9
Always use two people to lift and position the
machine. In addition to its weight, the size of
the HF-400 can place a single person in an
awkward or unbalanced position.
Adequate space should be provided near the
machine for flat and folded documents.

Power

10
Connect the HF-400 to a 120V power outlet
with the supplied cord. The cord plugs into the
socket (9) at the bottom right corner of the feed
end of the machine.
After set up is complete, the main power switch
(11) can be turned on to activate the machine.
The
T3.15AL250V fuses, one in the hot line and
one in the neutral. Both fuses must be in place
for the HF-400 to operate.
WARNING
Unplug the power cord before removing the
fuse drawer.
6
Feed Table Extension
If the feed table extension (6) has been folded
up, pull the feed table extension latch (7) and
32
lower the extension to the operating position.
For sheets longer than 14", pull out the long
paper support (32) to support the trailing edge
of the documents.
9
Rev. 12/04
fuse drawer (10)

Set Up

contains two