se of Water, Detergent, Bleach and Softener
Amount of WATER LEVEL
• This machine detects the quantity of laundry
automatically, then set the WATER LEVEL and
proper amount of Detergent.
• When you select a wash program, the WATER
LEVEL will be shown on the control panel.
• The following table shows the amount of water level.
• When the WATER LEVEL is automatically detected,
it may differ depending on the quantity of laundry
even though the same WATER LEVEL is indicated on the control panel.
[Minimum water amount]
It depends on laundry load and washer mode. Or manually you can pour a certain amount water into tub directly to some
height. That's because if water level reaches to the some height sensed by washer itself, washer automatically operates. In
other words, it is needed to pour water to the point when washer start operating.
If iron is present in the water the clothes may become an all-over yellow or they may be stained with brown or orange
spots or streaks. Iron is not always visible. Installation of water softener or an iron filter may be necessary for severe cases.
Follow the Detergent package directions. Using too little Detergent is a common cause of laundry problems.
Use more Detergent if you have hard water, large loads, greasy or oily soils or lower Water Temperature.
Choosing the right Detergent
We recommend the use of domestic Detergent, (powder, liquid or concentrated). Soap flakes or granulated
soap powders should not be used in your washing machine. When washing woolens remember to use
Detergent suitable for washing woolens.