Maintenance - Hill Audio DMW-300 User Manual

5.3.3. Settings
The jingle player can be configured to work in different ways, either as a one-shot jingle player or a
scheduled jingle player. Further, the level reduction of the background music during jingle replay can
be set. To make the required settings., enter the SET_MENU mode as described in chapter 5.1., and
scroll to SET_MENU>JINGLE_PLAY, then press the wheel to invoke ENTER. You will be presented with
two submenus:
Ducking Level. This allows you to set the level reduction of the background music during jingle replay.
Scroll to DUCKING_LEVEL and press the wheel to invoke ENTER. The current level setting will be
shown and you can adjust the value via the NAVIGATION wheel between -10dB and -60dB in 3dB
steps. Once the appropriate choice is made, press the wheel to invoke ENTER. The unit will return to
SET_MENU>JINGLE_PLAY.
Play Mode. This allows to set whether the jingle player works as a one-shot player or in schedule
play. Scroll to PLAY_MODE and press the wheel to invoke ENTER. Choose either SINGLE or SEQUEN-
TIAL by scrolling and confirm the choice by pressing the wheel to invoke ENTER. The unit will return to
SET_MENU>JINGLE_PLAY.
Note that any change will only be saved if you leave the SET mode with saving the changes, as
described in 5.1.
5.3.4. Operation
The jingle player can only be operated from the SOURCE_MENU mode. Depending on the settings
made in the SET_MENU mode (see 5.3.3.), invoking the JGL button will have the following effect:
If the play mode in SET_MENU>JINGLE_PLAY>PLAY_MODE is set to SEQUENTIAL (see 5.3.3.), then
pressing the JGL button once will activate the sequential jingle replay. The backlight of the JGL button
will change from constantly lit to flashing. The jingles stored on the USB media will be played according
to the sequence found in the jingle folder, with the relative period of background music following each
jingle and then this sequence loops. While playing a jingle, the background music will be lowered by the
amount specified in the settings for the DUCKING_LEVEL (see 5.3.3.). Pressing the JGL button once
again will stop the sequential jingle replay and the backlight of the JGL button will turn back from flash-
ing to constantly lit.
If the play mode in SET_MENU>JINGLE_PLAY>PLAY_MODE is set to SINGLE, then pressing the JGL
button will open a pop-up window prompting you to choose between the following options:
JINGLE1: J1 plays immediately for one time.
JINGLE2: J2 plays immediately for one time.
JINGLE3: J3 plays immediately for one time.
While playing a jingle, the background music will be lowered by the amount specified in the settings
for the DUCKING_LEVEL (see 5.3.3.). During replay of the selected jingle, the JGL button flashes, and
once the replay is finished, automatically turns to be constantly lit again.

6. Maintenance

The DMW300 offers various maintenance functions. Due to such functions being intended to be only
used by the installer/configurator, they are located in the SET_MENU mode. Scroll with the naviga-
tion wheel to SET_MENU>MAINTENANCE and press the wheel to invoke ENTER. You will be presented
with four available submenus:
Machine ID
HW/SW version
Check update
Factory default
6.1. Machine ID
You might be required to provide the machine ID to service personnel or for on-line service registra-
tion. Machine ID comprises of 8 4-character strings in hex. You may be required to provide this
number to the service people for machine identification. To see the Machine ID, scroll to
SET_MENU>MAINTENANCE>MACHINE_ID and and press the wheel to invoke ENTER. The machine ID
will be displayed.
PAGE 19
USER MANUAL - DMW300 NETWORK | FM | USB RECEIVER & PLAYER