Table of Contents
Advertisement
5. OPERATION
5.1. SET_MENU MODE
As explained, the SET_MENU mode mainly serves for the installer and configurator to set up the unit
for first use, or to adjust the units' settings to a changed environment or changed user requirements.
To avoid accidental setting changes being made, the access to the SET_MENU mode has been
restricted by means of a multi-step access sequence.
To enter the SET_MENU mode, expedite the following access sequence:
Press the SET button for more than 2sec, the display will show „Enter SET Mode?" with two below
entries, "No" and "yes", default is "No" (highlighted).
Scroll by turning with navigation wheel clockwise to "Yes" (below "No"),
Confirm by pressing the navigation wheel
The display will show "press Set for 2 sec", follow the instruction and press SET for 2 seconds.
After this, you will be in the SET_MENU mode, the display will show SET_MENU with entries listed
below as documented in the menu tree. If you fail to complete the above access sequence, the unit will
simply return to the SOURCE_MENU mode, and you will need to start over if you intend to access
SET_MENU mode.
To navigate inside SET_MENU mode, do the following:
Turn the navigation wheel to right (cw) to scroll down, to left (ccw) to scroll up
Press the wheel to confirm current selection (enter)
Press BACK to move one level higher in menu tree
To leave SET_MENU mode, do the following:
Press SET for more than 5 seconds. The unit will save all applied changes and return back to
SOURCE mode.
Note: the SET LED blinks during editing and turns to constantly lit onces changes are stored and the
unit returns to SOURCE_MENU mode.
5.1.1. Initial setup
Power up the unit and make sure a broadband internet connection is available as described. Enter the
SET mode as explained in previous chapter 5.1.
5.1.1.1. Setting the user interface language
Make sure you are in the SET_MENU root and navigate to SET_MENU>LANGUAGE, then press the
wheel to invoke ENTER. A list of available language will appear Scroll to the language you require
(current position is highlighted) and press press wheel to invoke ENTER. Available languages are
English, German, French, Spanish, Portugese and Chinese. Once the language has been chosen, the
user interface will change the language immediately and the unit returns to the higher menu level, in
this case SET_MENU.
Note: For convenience - in case the unit is accidentally set to the wrong language – the menu path to
the SET_MENU>LANGUAGE menu is indicated with a flag symbol to allow you to locate the language
settings even if you can not read the current language.
PAGE 9
USER MANUAL - DMW300 NETWORK | FM | USB RECEIVER & PLAYER
Advertisement
Table of Contents
