Pioneer DEH-80PRS Operation Manual page 29

Operating this unit
Performing auto TA and EQ
1 Stop the car in a place that is quiet,
close all the doors, windows and sun roof,
and then turn the engine off.
# If the engine is left running, the noise from
the engine may cause incorrect auto TA and EQ.
2 Fix the supplied microphone in the cen-
ter of the headrest of the driver's seat, fa-
cing forward.
# The auto TA and EQ may differ depending on
where you place the microphone. If desired, place
the microphone on the front passenger seat to
perform auto TA and EQ.
3 Turn the ignition switch to ON or ACC.
# If the air conditioner or heater is turned on,
turn it off. The noise from the fan may cause in-
correct auto TA and EQ.
# Press SRC/OFF to turn the source on if this
unit is turned off.
4 Select the position for the seat on
which the microphone is placed.
Refer to Using the position selector on page
20.
# If no position is selected before auto TA and
EQ is started, Front Left is automatically se-
lected.
5 Press SRC/OFF and hold until the unit
turns off.
6 Press and hold EQ/DISP OFF to enter
the auto TA and EQ measurement mode.
The front panel opens automatically.
7 Plug the microphone into the micro-
phone input jack on this unit.
8 Press M.C. to start the auto TA and EQ.
9 When the 10-second countdown starts,
get out of the car and close the door within
10 seconds.
The measurement tone (noise) is outputted
from the speakers, and auto TA and EQ be-
gins.
# When all speakers are connected, auto TA
and EQ is completed in about six minutes.
# To stop auto TA and EQ, press M.C. again.
# To cancel auto TA and EQ part way through,
press BAND/ .
10 When auto TA and EQ is completed,
Complete is displayed.
When correct measurement of car interior
acoustic characteristics is not possible, an
error message is displayed. (Refer to Auto TA
and EQ on page 41.)
11 Press BAND/ to cancel the auto TA
and EQ mode.
12 Store the microphone carefully in the
glove compartment or another safe place.
If the microphone is subjected to direct sun-
light for an extended period, high tempera-
tures may cause distortion, color change or
malfunction.
Section
02
29
En